The HTTP function is only implemented for the SIMCOM modules. TCP conenction is configured for transparent mode Transparent or non-transparent IP conenction mode Connection profile – Circuit-switch or GPRS Is the modules configured for server mode? IP header is added, format is “+IPD,data length” Primary and secondary DNS configuration Check if the PDP context has been activated TCP and UDP are configured to use following ports TCP connection is closed by remote serverĭevice configured for multi IP connection This is current configuration TCP context Simcom module Audio channel configuration Get the list of emergency numbers programmed in the Simcom moduleĮmergency numbers are :”112″,”911″,Mic gain values for for channels: Check if temperature detection is enabledĭevice configured for GPRS multislot class of 10 Check if SIM is inserted in Simcom module Check if engineerign mode is on in Simcom moduleĮngineering mode is OFF. SMS service center address is “+34609092815” SMS message for is configured for Text mode Please wait as this could take sometime…. Signal condition is excellent.The signal strength range is -53 dbm (Excellent) to -109 dbm (Marginal). Radio Link Protocol (RLP) Configuration paramaters: Simcom module QoS (Quality of Service) profilesįollowing Quality of Service (QoS) profiles are available,īearer Service -> Data circuit asynchronous

Check if Simcom module is attached to the network Here the AT Command Tester tool sends the required AT commands and provides descriptive output about the state of the modem. Users can perform basic troubleshooting of the modem diagnostics under the ‘Diagnostics’ tab.

Set-up dial-up connection with SIM7000X modules.

Test PING feature with SIM7000X modules.

HTTP connection with SIM7500X, SIM7600X, SIM7100X and SIM53XX modules.

HTTP connection for SIM7000X and SIM800X Modules.

TCP connection with SIM7500 and SIM7600 modules.

TCP connection with SIM7000X, SIM800X & SIM53XX Modules.

With the online AT command tester tool, this tutorial explains how to to test different AT interfaces available on Simcom modules. This tutorial is intended for developers building M2M applciations with Simcom modules. All the modules offers a rich set of AT command interface for developing IP-based applications.

Simcom offers a range of 2G and 3G M2M modules. ( Leave a comment ) Tutorial for SIMCOM M2M Modules.

At Command Tester Software